Sync. Cables For ikelite Subtrobes, Nikonos (SB-series) Speedlights, and Sea&Sea YS-Duo connector.

---

Sync. Cables for ikelite Housings (ikelite connector at both ends) Digital TTL cords, marked with a blue band, provide power from Substrobe to slave adapter or TTL conversion module (older cords only had 4 wires - one pin was unused).

Coiled cord, ICS5 to ICS5, 5 wires. TTL sync cable for Substrobe + ikelite housing, Long cord for 2800 video light, etc. ikelite #4103.51 £85.00 inc. VAT Video light cable / TTL sync cord, 24″ straight ICS5 to ICS5, 5 wires ikelite #4103.5 £79.99 inc. VAT TTL Dual Sync cord, 2 ikelite strobes to ikelite housing ikelite #4103.52 £139.99 inc. VAT

---

Non TTL Cables for non-Ikelite DSLR Housings - Nikonos Connector
Needed for Nikon and Canon housings without TTL conversion module.
i.e. For Digital Aquatica, Subal, Sea & Sea, Nexus housings, etc.

2 wire Manual sync cable 1 ikelite strobe to Housing with Nikonos V socket ikelite #4104.31 £85.00 inc. VAT 2 wire Manual Dual sync cable 2 ikelite strobes to Housing with Nikonos V socket ikelite #4104.32 £139.99 inc. VAT

Flash units using the Nikonos TTL flash protocol do not operate correctly with D/iTTL and eTTL cameras, but most housing manufacturers bring all of the DSLR hot-shoe connections out to the socket so that you can use a camera-dedicated flash in an underwater housing.  When a Nikonos compatible flash is used directly with the camera, only the x-sync and ground wires should be connected.  The Ikelite cables listed above leave out the TTL system connections (which cause camera errors when misconnected), allowing any Ikelite Substrobe to be used in manual mode. If a standard (fully populated) cable is used, the TTL connections can be disabled with tape on the hot shoe, as shown below.

To use a normal Ikelite - Nikonos sync cord, or other Nikonos compatible flash with the Nikonos socket on a DSLR housing; you can disconnect the hot-shoe contacts shown in the illustrations (left and right) or cover the contacts with insulating tape. Always leave provision to put the connections back as standard: you may later wish to upgrade to iTTL or eTTL compatible UW flash equipment.

---

Sync. Cables with Nikonos Connector (Ikelite Substrobe ? Nikonos TTL) For Nikonos III, IV, V, RS, Sea & Sea Motormarine III, and 35mm Aquatica, Subal, Sea & Sea (Not SX), Nexus housings, etc.  Only 4 wires are used in the Nikonos plug (SP is connected to ground via 3.3K? resistor).  Hence will not work to connect TTL flash with N5 connector to ikelite camera housing.

Nikonos TTL Sync cord, 1 ikelite strobe To Nikonos V socket ikelite #4104.6 £85.00 inc. VAT Nikonos TTL Sync cord (short 46cm), 1 ikelite strobe To Nikonos V socket ikelite #4104.51 £79.99 inc. VAT Nikonos Dual TTL Sync cord, 2 ikelite strobes To Nikonos V socket ikelite #4104.62 £139.99 inc. VAT

---

Cables for Sea & Sea and Inon Strobes Sea & Sea Duo Connector to ICS5 For ikelite housings with 5-pin bulkhead connector - manual sync. only

Manual Sync cord 1 Sea and Sea or Inon Strobe to ikelite housing ikelite #4118.1 £85.00 inc. VAT Manual Sync cord 2 Sea and Sea or Inon Strobes to ikelite housing ikelite #4118.2 £139.99 inc. VAT

---

Cables for Nikonos SB-102, 103, 104, 105 Speedlights

Nikonos Speedlights - ikelite ICS5 socket on housing

Manual Sync cord 1 Nikonos Speedlight to ikelite housing ikelite #4116.31 £85.00 inc. VAT Manual Sync cord 2 Nikonos Speedlights to ikelite housing ikelite #4116.32 £139.99 inc. VAT

Nikonos Speedlights - Nikonos V socket on housing

Nikonos TTL sync cord 1 Nikonos Speedlight (SB102, SB103, SB105) To Nikonos V socket ikelite #4115.1 £85.00 inc. VAT Nikonos TTL sync cord 2 Nikonos Speedlights (SB102, SB103, SB105) To Nikonos V socket ikelite #4115.2 £139.99 inc. VAT

---

Extension cables  ikelite Male - ikelite Female

Extension cord 0.9m (3') ikelite male to ikelite female ikelite #4102.03 £79.99 inc. VAT Extension cord 4.50m (15') ikelite male to ikelite female ikelite #4102.15 £79.99 inc. VAT

---

Connector spares
Ikelite O-rings are nitrile-butadiene rubber (NBR).  The correct lubricant is silicone grease.
 The O-ring 0118 has a smaller cross-section diameter than the P9 O-ring used on Nikonos plugs of Japanese manufacture (the O-ring groove diameter of Ikelite plugs is 9.35mm, whereas Sea & Sea plugs have an O-ring groove diameter of 9.1mm). Hence the Ikelite O-ring should only be used on Ikelite Nikonos connectors. Using a Japanese O-ring on an Ikelite connector will make the plug stiff to insert.

Connector protector for 2 ikelite connectors ikelite #0301 £10.00 inc. VAT Connector protector for 1 ikelite & 1 Nikonos ikelite #0301.1 £10.00 inc. VAT Connector protector for 1 ikelite connector ikelite #0301.12 £10.00 inc. VAT O-ring for SB (speedlight) connector ikelite #0117 £1.00 inc. VAT O-ring for sync cord, Nikonos end of cord ikelite #0118 £1.00 inc. VAT O-ring for ICS5 plug ikelite #0136.13 £1.00 inc. VAT Waterproof blanking cap for ICS5 socket includes O-ring 0136.13 ikelite #9104.5 £13.99 inc. VAT Silicone grease 1cc (pack of 4) ikelite #5020 £1.75 inc. VAT

Connectors and hole plugs
Conform to or exceed IPX8, 6 Bar.
 The price of these OEM / service parts does not include technical support.  Fitting of miniature electrical connectors requires considerable skill.  All newly made waterproof assemblies require pressure testing before use.
Cameras Underwater accepts no liability whatsoever for faulty assembly or installation.

ICS 5 plug Components (5 pin) ikelite #9104.15 £22.00 inc. VAT ICS5 Bulkhead Socket components (5 pin) ikelite #9104.55 £22.00 inc. VAT Nikonos V plug components, Delrin collar Supplied with 3.3KΩ resistor wired from SP to ground ikelite #9103.07 £70.00 inc. VAT Cable gland, 1/2″ hole, Bulkhead thickness 10mm max ikelite #4006 £19.99 inc. VAT Hole plug, 3/8″ Dia. Bulkhead thickness 22mm max ikelite #9237 £7.00 inc. VAT Hole plug, 1/2″ Dia. Bulkhead thickness 5 -7mm when using standard length fixing bolt ikelite #9238 £7.00 inc. VAT